Pump FP-15000 130W h=6.5m

Pond, cascade, fountain pump 15000l/h
 

The FP series pumps are characterised by high efficiency and low energy consumption. The pumps provide lower (up to 60%) energy consumption than standard competitor water pumps.

The pumps are ideal for use in filtration systems (pressure and overflow filters, UV lamps), cascades and decorative fountains. High-quality workmanship, innovative electrical installation ensure quiet and trouble-free operation, and the ceramic, abrasion-resistant impeller shaft allows the pumps to be used in fresh and salt water. The casing - a prefilter, retains larger impurities, thus protecting the impeller from damage and ensuring long pump operation (even in very polluted bodies of water).For safety, the pump incorporates a thermal switch to protect against overheating. Power cable, long - 10m , specially protected in rubber insulation. The impeller with a ceramic stem ensures long and trouble-free operation.

The new FP series of pumps is equipped with an external controller board. The introduced plate is intended to increase reliability. In addition, the connector to the electrical board is smaller than the end of the power cable (it is approximately 24mm in diameter), allowing for easier installation and cable routing. The board has a waterproof rating of IP68, which means that it cannot be placed in water, it must be shielded from rain, e.g. in foil.

Advantages:

- Innovative motor design

- Very quiet pump operation

- Wear-resistant ceramic impeller shaft

- High capacity of 15000l/h

- Low motor current consumption

- Protective basket - prefilter

- Electronic IC protection, automatic disconnection in case of lack of water

- Suitable for continuous operation

- Non-slip feet

- Comfortable carrying handle

- Suitable for pumping debris up to 6mm in size

- Stubs - the pump can be connected with hoses of diameters: 25, 32, 38, 50 mm (1, 1 1,/4 , 1 1/2, 2 inches)

- Simple operation and maintenance

- New version with external electrical board for lower failure rate

TECHNICAL DATA:

Max flow rate: 15000l/h

Motor power consumption: 130W

Max. lifting height: 6.5m

Dimensions: 280x145x145mm

Length of power cable: 10m

Outlet tips: 25, 32, 38/40, 50mm (1, 1 1,/4 , 1 1/2, 2 inches)